Made in the USA America

The PT Hub and MP-360 tripod head can be used to wirelessly move the direction of your camera. The device can rotate 360 degrees, as well as allow the user to adjust the tilt of the camera. To use the PT Hub and motorized tripod head, a CamRanger (original, mini, or 2) and supported camera are required.

Specifications

  • Power Source: 4 AA batteries or A/C adapter (neither included)
  • Vertical Tilt: +/- 15 degrees
  • Horizontal Pan: 360 degrees with unlimited rotation
  • Maximum Camera Weight: 6 lb (2.7 kg)
  • Size (LxHxW): 5.75 x 4.5 x 4 inches (145 x 115 x 103 mm)
  • Weight: 1.75 lb (800 g)
MP-360 Motorized Tripod Head

PT Hub Hardware

  • USB A Connector – Connects to CamRanger
  • Serial Connector – Connects to PT Hub
  • USB B Connector – Connections to camera

MP-360 Motorized Tripod Head Hardware

  • Threaded Mounting Point – 1/4” 20 threaded female opening for mounting to an existing tripod head (does NOT mount directly onto tripod legs)
  • Battery Compartment – Open the battery compartment by sliding the cover downward and then lifting it outward. Insert 4 AA batteries oriented according to the markings in the battery compartment. The MP-360 may also be powered by an AC adapter.
  • Power LED – Green when power is on (cannot be used to determine battery level)
  • Power Switch – To turn on, set to “M”
  • Camera Mounting Screw – 1/4” 20 mounting screw

Setup

Required Parts:

  • CamRanger (original, mini, or 2)
  • PT Hub
  • Motorized Tripod Head (MP-360, Bescor, or Hague) with batteries or AC adapter
  • USB cable for camera connection
  • Serial Cable (included with PT Hub)
  • USB A to B cable (included with PT Hub)
  • Camera
  • Device with the CamRanger app (iOS/Android/macOS/Windows)
CamRanger, PT Hub, MP-360 motorized tripod head setup
  • Connect the CamRanger, PT Hub, tripod head, and camera as shown in the above diagram. Make sure the cables are securely connected.
  • Set the tripod head power switch to “M” to turn on the tripod head.
  • Setup and start the rest of the equipment as normally done.

App Additions with the PT Hub and Tripod Head

When the CamRanger app is started with the PT Hub and MP-360 connected, a tripod button will appear next to the other tab buttons.

The CamRanger app will appear slightly different depending on the device used, but all are very similar.

Android Tripod Button
motorized tripod head control

A directional pad is displayed on the tripod tab.

Press and hold to move the tripod head in the desired direction. Double tapping will continue to move the tripod head in that direction until the directional pad is tapped again. The slider below the directional pad controls the pan/tilt speed of the tripod head. The approximate MP-360 battery charge is shown at the top left

Note: The panorama button in the bottom left appears only for iOS and Android devices.

The panorama button at the bottom left expands the tripod tab to display the controls for configuring an automated panorama.

To perform a panorama, a calibration must first be performed. To calibrate, press the “Calibrate” button and follow the steps. The calibration is valid for four hours, until the session is restarted, or the tripod head speed is adjusted.

Android Motorized Tripod Head Automatic Panorama

After calibrating, the number of shots, total number of degrees, and panorama direction can be specified before pressing “Start” to begin the process.

Table of Contents